News

IEC 62271 in Plain Language: Which Part Applies to Disconnectors, Switches and Switch-Fuse Combinations

Published: 2026-11-17 09:00:00 Views: 4

The Problem With "It Meets IEC 62271"

"Complies with IEC 62271" is not a specification. The series runs to dozens of parts, and each part covers a different device or assembly. Quoting the wrong one in a tender is a common and expensive mistake, because type-test evidence for one part does not transfer to another.

The Parts That Matter at Distribution Level

PartWhat it covers
IEC 62271-1Common specifications for AC switchgear and controlgear — the definitions, ratings and test philosophy the other parts build on
IEC 62271-100AC circuit-breakers
IEC 62271-102AC disconnectors and earthing switches
IEC 62271-103AC switches (current edition 2023) for rated voltages above 1 kV up to and including 52 kV
IEC 62271-105AC switch-fuse combinations (current edition 2023) for rated voltages above 1 kV up to and including 52 kV
IEC 62271-107AC fused circuit-switchers, 1 kV to 52 kV
IEC 62271-200AC metal-enclosed switchgear and controlgear, 1 kV to 52 kV
IEC 62271-201AC solid-insulation enclosed switchgear and controlgear, 1 kV to 52 kV
IEC 62271-202High voltage / low voltage prefabricated substations
IEC 60282-1High voltage current-limiting fuses — the fuse half of any combination

The Three That Are Most Often Confused

  • A disconnector is not a switch. A disconnector (IEC 62271-102) provides an isolating gap and is not required to break load current. A switch (IEC 62271-103) is. If a datasheet quotes 62271-102 for a device you intend to open on load, that is a red flag.
  • A switch-fuse combination is its own device. Under IEC 62271-105 the combination is defined by its type designation plus a reference list of fuses. Compliance applies to the specific switch-plus-fuse pairing, not to the switch alone — so substituting a different fuse type without re-verifying the combination invalidates the claim.
  • Metal-enclosed and solid-insulated assemblies are covered separately. A 12 kV panel may fall under IEC 62271-200 or, if it uses solid insulation, IEC 62271-201 — and the applicable part changes what tests apply to the whole assembly.

What Changed in the 2023 Editions

The 2023 revisions of IEC 62271-103 and 62271-105 tightened the way combinations are declared and tested. IEC 62271-105 requires the fuses to be fitted with strikers, so that operation of any fuse opens all three poles of the switch, and it explicitly handles the awkward band of fault current between a fuse's minimum melting current and its minimum breaking current. It also excludes combinations requiring dependent manual operation — a small clause with large consequences for anyone specifying an operator-dependent design.

How to Use This in a Tender

  • State the part number, not just the series — and state the edition.
  • For combinations, require the reference list of fuses with the type designation.
  • Ask for the type-test report against that part, from a recognised laboratory, with the tested configuration matching what is being supplied.
  • Where a device performs more than one function — for example a disconnector that also provides earthing — confirm it satisfies each relevant part.
Inquiry
Verification code
WhatsApp QR Code

Scan to chat on WhatsApp
+86 199 5773 9581